1. Data group identifier, one input line ELAStic CONTact SURFace 2. Specification of elastic contact surface(s), one input line NSURFE NSURFE: integer > 0: The number of elastic contact surfaces to be specified 3. Description of the contact surface(s) and specification of the line(s) which may experience contact with the surface(s). The lines below, Number of contact points…, Type and location of contact point… and Specification of lines to be checked…, must be given in one block for each elastic contact surface. Number of contact points along the current contact surface and number of lines which may experience contact with the surface, one input line. NCNODE NCLINE NCNODE: integer > 0: Number of contact points located on the present contact surface NCLINE: integer > 0: Number of lines to be checked against contact with the present surface Type and location of contact point, NCNODE input lines ICNOD LINE-ID ISEG IEND CNTTY TENTY TUBTY ICNOD: integer: Contact point number LINE-ID: character(8): Reference to line identifier ISEG: integer: Local segment number IEND: integer: Local segment end (1 or 2) CNTTY: character(8): Reference to roller contact type identifier (CMPTYP-ID) TENTY: character(8), default: NONE: Reference to tensioner contact type identifier (CMPTYP-ID) TUBTY: character(8), default: NONE: Reference to tubular contact identifier (CMPTYP-ID) 1< ICNOD < NCNODE; icnod must be given in increasing order. The line number (ILIN) refers to the line number given implicit in the riser specification. NOTE: CNTTY, TENTY and TUBTY refers to CMPTYP-ID: New component specification. CNTTY = NONE or 0 means no roller contact at the actual contact point. TENTY = NONE or 0 means no tensioner at the actual contact point. TUBTY = NONE or 0 means no tubular contact at the actual contact point. Roller and tubular contact are activated by the ROLL command in the incremental static loading procedure. Tensioner type of contact is activated by the TENS command. Specification of lines to be checked for contact with the current contact surface, NCLINE input lines. LINCHK ISEGF IELF ISEGL IELL LINCHK: character(8): Reference to line identifier (LINE-ID) to be checked for contact with the current contact surface. ISEGF: integer, default: 1: First local segment within the line to be checked for contact. IELF: integer, default: 1: First local element within the segment to be checked for contact. ISEGL: integer, default: 0: Last local segment within the line to be checked for contact. IELL: integer, default: 0: Last local element within the segment to be checked for contact. IELL = 0 means that the last element which will checked for contact is the last element within the segment ISEGL. ISEGL = 0 means that the last segment which will be checked for contact is the last segment within line ILCHCK. Main riser line Pipe-in-pipe contact